Standard Svensk standard · SS-ISO 12494:2017

Nedisning av konstruktioner på grund av fukt i luften (ISO 12494:2017, IDT)

Status: Gällande

Köp denna standard

Standard Svensk standard · SS-ISO 12494:2017

Nedisning av konstruktioner på grund av fukt i luften (ISO 12494:2017, IDT)
Prenumerera på standarden - Läs mer Dölj
Pris: 1 615 SEK
standard ikon pdf

PDF

Pris: 1 615 SEK
standard ikon

Papper

Pris: 2 584 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ
Provläs denna standard
Omfattning
ISO 12494:2017 describes the general principles of determining ice load on structures of the types listed in this clause.
In cases where a certain structure is not directly covered by this or another standard or recommendation, designers can use the intentions of this document. However, it is the user's responsibility to carefully consider the applicability of this document to the structure in question.
The practical use of all data in this document is based upon certain knowledge of the site of the structure. Information about the degree of "normal" icing amounts (= ice classes) for the site in question is used. For many areas, however, no information is available.
Even in such cases, this document can be useful because local meteorologists or other experienced persons should be able to, on the safe side, estimate a proper ice class. Using such an estimate in the structural design will result in a much safer structure than designing without any considerations for problems due to ice.
CAUTION It is extremely important to design for some ice instead of no ice, and then the question of whether the amount of ice was correct is of less importance. In particular, the action of wind can be increased considerably due to both increased exposed area and increased drag coefficient.
ISO 12494:2017 is intended for use in determining ice mass and wind load on the iced structure for the following types of structure:
- masts;
- towers;
- antennas and antenna structures;
- cables, stays, guy ropes, etc.;
- rope ways (cable railways);
- structures for ski-lifts;
- buildings or parts of them exposed to potential icing;
- towers for special types of construction such as transmission lines, wind turbines, etc.
Atmospheric icing on electrical overhead lines is covered by IEC (International Electrotechnical Commission) standards.
This document is intended to be used in conjunction with ISO 2394.
NOTE Some typical type ...

Ämnesområden

ISO-standarder för bärverksdimensionering (91.070.10) Eurokod, övrigt (91.070.80) Byggnadsstommar Allmänt (91.080.01)


Köp denna standard

Standard Svensk standard · SS-ISO 12494:2017

Nedisning av konstruktioner på grund av fukt i luften (ISO 12494:2017, IDT)
Prenumerera på standarden - Läs mer Dölj
Pris: 1 615 SEK
standard ikon pdf

PDF

Pris: 1 615 SEK
standard ikon

Papper

Pris: 2 584 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ

Produktinformation

Språk: Engelska

Framtagen av: Eurokoder, SIS/TK 203

Internationell titel: Atmospheric icing of structures (ISO 12494:2017, IDT)

Artikelnummer: STD-8029447

Utgåva: 2

Fastställd: 2017-11-06

Antal sidor: 76

Ersätter: SS-ISO 12494