Standard Svensk standard · SS-ISO 4633:2020

Tätningsringar av gummi - Tätningsringar för vatten- och avloppsledningar - Materialkrav (ISO 4633:2015, IDT)

Status: Gällande

Köp denna standard

Standard Svensk standard · SS-ISO 4633:2020

Tätningsringar av gummi - Tätningsringar för vatten- och avloppsledningar - Materialkrav (ISO 4633:2015, IDT)
Prenumerera på standarden - Läs mer Dölj
Pris: 755 SEK
standard ikon pdf

PDF

Pris: 755 SEK
standard ikon

Papper

Pris: 1 208 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ
Omfattning
This International Standard specifies requirements for materials used in vulcanized rubber seals for the following:
a) cold drinking-water supplies (up to 50 °C);
b) drainage, sewerage, and rainwater systems (continuous flow up to 45 °C and intermittent flow up to 95 °C).
The different designations of seals specified are defined according to their type, application, and requirements (see Table 3).
General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards, taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry, and pipe joint design. This International Standard is intended to be used, where appropriate, with product standards which specify performance requirements for joints.
This International Standard is applicable to joint seals for all pipeline materials, including iron, steel, clay, fibre cement, concrete, reinforced concrete, plastics, and glass-reinforced plastics.
It is applicable to elastomeric components of composite or non-composite seals. In the case of composite seals for materials of hardness ranges from 76 IRHD to 95 IRHD, the requirements for elongation at break, compression set, and stress relaxation apply only when the material is participating in the sealing function or in the long term stability of the seal.
Joint seals made with an enclosed void as part of their design are included in the scope of this International Standard.

Ämnesområden

Tätningar (83.140.50) Vatteninstallationer (91.140.60) Avloppsinstallationer (91.140.80)


Köp denna standard

Standard Svensk standard · SS-ISO 4633:2020

Tätningsringar av gummi - Tätningsringar för vatten- och avloppsledningar - Materialkrav (ISO 4633:2015, IDT)
Prenumerera på standarden - Läs mer Dölj
Pris: 755 SEK
standard ikon pdf

PDF

Pris: 755 SEK
standard ikon

Papper

Pris: 1 208 SEK
standard ikon pdf + standard ikon

PDF + papper

Fler alternativ Färre alternativ

Produktinformation

Språk: Engelska

Framtagen av: Gummi och gummiprodukter, SIS/TK 154

Internationell titel: Rubber seals - Joint rings for water supply, drainage and sewerage pipelines - Specification for materials (ISO 4633:2015, IDT)

Artikelnummer: STD-80020277

Utgåva: 2

Fastställd: 2020-02-21

Antal sidor: 20

Ersätter: SS-ISO 4633